Instead of using a command-line to set the fan speed, an app would overwrite the text file, and FanControl would periodically read the file. One of the commenters suggested an alternative that would be easier to implement than command-line parameters: treat a text file like a temperature sensor. Control your fans based on all temperatures, like CPU, GPU, Mainboard, AIO liquid and external. (This is a hint to you to request it too.) I imagine it wouldn't take much time for the dev to implement it. SpeedFan is a hardware monitor software that can access temperature sensors, but its main feature is that it can control fan speeds depending on the capabilities of your sensor chip and your. Take a look a the best Fan Control Software for Windows. Perhaps if enough people request it, the developer will implement it. FanSet uses OpenHardwareMonitorLib to set your motherboard fans easily via the commandline. ![]() I'm probably late for you, but leaving this here for posterity. However, you hinted that being able to reset the fan back to automatic (by command-line) is another one of your requirements, but you didn't literally say it is.Īt least two commenters have requested adding a command-line feature to FanControl. 1 The other day I needed something like this and made my own solution. I had to reset my Windows 10 PC and now cant find a download. As you guys may know, SpeedFan is sadly not updated anymore, so newer boards are not detected properly. agoLevel 1 10-23-2017 07:55 AM Product: OMEN by HP 15-ax248tx Operating System: Microsoft Windows 10 (64-bit) I would like to control my laptop fan speed. 0 Extreme, which requires Thermaltake Fan Control Software as the fans are controlled by. Assuming it understands your motherboard hardware, I think you could use it to set a constant fan speed of your choosing by constructing a constant control curve. To run at startup: Use the new 'Start with Windows' option in the left hamburger menu I built a new custom UI on top of OpenHardwareMonitor with additional features, mainly linear fan curves with custom temperature sources. ![]() FanControl doesn't accept command-line parameters, so it's not a perfect match for your request, but perhaps you can use it to solve your problem.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |